Search results

Hi guys!Would need a new or remanufactored crank.Stock stroke!Unfortanly the scat cranks are discountinued and no more cranks are listed on syty performance!!:( Found some on ebay...what do you think...

Hi! I installed a snow performance alky injection in my ty and it works fine except of one problem.When the alky starts to spray my innovate wideband goes to preheating again after a short period of time.It shows 7.4 on my display as it does the first seconds after start up with the only...

Hi guys! As i tune with code59 now i want to get rid of my old tuning chips. For sale are: 1x STG Ultimate Chip for 3 bar map sensor and stock injectors - Gauge Design: SOLD 1x 10 in 1 Chip from Brian Green for stock map sensor: 100$ 1x ATR Street Chip perfect for stock engines : 100$...

Hi guys! Used the search button but didnt find anything! My question is:would a TC of a 4L60E fit on our TH700R4?I think its the same tranny exept of the electrical,but i am not sure... By the way,do you think the stall is big enough for a PTE72GTQ? Thanx in advance...

Hi! My question is,could knock cause a broken main/rod bearing?I ask because yesterday i drove the ty for about 80 miles and i had a few times a knock retard of max. 5-6degrees and now i think the bearings are worn because the oil pressure is not so high as before and when i turn the engine off...

Hi Guys! Wanna order a single spring front coil over setup for my ty but i am not sure about the spring rate!Does anyone of you have any experience on these?Will drive the ty lower than stock and want a sporty ride but not to hard. Thanx in advance, Alex

Hi! I am looking for an bigger upper intercooler like the typhoon c had.I know ATR made them but they are out of busines.Maybe somebody has this thing laying around and want to sell it?? greets Alex

Hi guys! Have a problem on the third and fifth cylinder.Only these two plugs looks like shit.Kompression on these cylinders is okay(11,8 and 12.5bar).Timing is set.Distributorbase,rotor and cables are new.Tried ngk and champion plugs.Always the same problem!Datamaster file shows knock.Any idea...

Hi guys! Have installed my Rpm stage3 Turbo with internal wastegate but dont know exactly how to adjust the wastegate rod.Know i have set it that the gate is closed and the rod exactly fits.But i only reach 7psi.Do i have to set the rod tighter? greets,Alex

Can i go with a 20G and 60 mototrons or are the injektors to big?(code $59) greets

Hi guys! Have a Mitsu turbo laying around and wondering if its a 20G because the inlet looks a bit bigger than the stock one. How can i see from outside what kind of mitsu it is? Thanks a lot! greets, Alex