wtf, got stock memcals

Nitrous

New member
Re: wtf, got stock memcals

I have a Kenne Belle chip I purchased with a set of Kenne Belle 40# injectors. Once installed it ran like crap so I ditched the Kenne Belle, got an Ostrich and TunrtPro RT anda little help from Rob "Wyoming" and walla, the truck runs great! I just have some fine tuning to do to make it perfect. I'm saving the Kenne Belle as an extra to burn a new tune on. Hope you get it running right.
 

SYO237

SyTy Registry
Re: wtf, got stock memcals

Since it's relevant for this thread, this is how to check your MAP sensor to distinguish between 2 and 3 Bar.

mapsensor.jpg
 

88GTZ

Donating Member
Re: wtf, got stock memcals

As far as FP goes, I have mine set at 48 with vacuum line ON. If I go any less, it doesn't run right. My Ty was like that, Abe's Ty was like that, Austin's Sy was like that, my wife's Ty is like that. Don't be afraid of 50psi up here.

I'm a little higher than you, 7400 ft here. Idk what springs elevation is...I know its not going to be as fast up here as 1000ft but I know it should run better than what it does...once again thanks for the replies...the truck doesn't run terrible with the kb just know its not up to par
 

TYTILIDIE

METH HEAD
Re: wtf, got stock memcals

We are at about 6000 feet in the Spings. I didn't realize Alamosa was that high. I have driven through there a few times and didn't really notice a difference but at the same time I was far from home and not really beating on it. I did notice in Breckenridge though that my power was crap up there at 9000. Major difference.
 

88GTZ

Donating Member
Re: wtf, got stock memcals

yeah most people don't realize how high we are, can't help laughing at that comment... have you taken your truck up pike's peak, I really want to do that this summer...
 

TYTILIDIE

METH HEAD
Re: wtf, got stock memcals

yeah most people don't realize how high we are, can't help laughing at that comment... have you taken your truck up pike's peak, I really want to do that this summer...

You know I have lived here since 1991 and have yet to go to Pikes Peak. Pretty sad I guess.
 

88GTZ

Donating Member
Re: wtf, got stock memcals

2 bar map... lower rad leaking, haven't checked fp yet. Will once replace and stop the leak. Also doesn't seem to boost 14.5 unless boost launched, does through second after loosed boost will tune help that or is it turbo? Thanks again..
 

88GTZ

Donating Member
Re: wtf, got stock memcals

Fp was 56 with vac disconnected and plugged, I lowered to 48. I will see how it runs in the morning. Also I want rid of mech fan, I see u run 02 stratus fans. How do u control them? Thanks again...
 

Fighting5thSVT

Active member
Re: wtf, got stock memcals

The factory chip had a setting that does not allow you to get full boost at your first WOT until you got WOT a second time. Everytime you start the truck it resets itself. You have to floor it once before you get the full effect on the second act of flooring it. I don't know if that applies to you with whatever chip you have right now.
 

88GTZ

Donating Member
Re: wtf, got stock memcals

I have a kenne bell chip... it almost never full boosts in third and fourth gear, I don't understand whether its boost control or turbo or chip...
 
Top