Re: Ostrich HELP!
I don't mean to hijack the thread but I am having the same issues. I can upload a bin and verify but it seems to run in limp mode and I cannot connect with datamaster. I have searched, read and tried any suggestions i can find.
The battery on the 2.0 seemed to be soldered on and not easily removed to try to swap it out.
I have emailed moates and am waiting for another reply from Dave. So maybe we're having some of the same issues.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> It seems the ostrich in not connecting to the ecm. The ribbon cable seems
> fine; tested each pin in the 28 pin ribbon to the socket and with the ZIF
> on it for continuity. I might have tested it through the G1 also but I
> can't remember. I can load a bin and verify just fine. I am using tunepro
> rt and I also saw some mention using the bank drop down to select a bank
> (used 0). I tried loading bin with emc conneted key on and key off, and not connected to
> ecm.
>
> Notes:
> - files used: Code59_3bar_1.5_v18_Rev4.xdf, Code59_3Bar_1.1.ads, and
> Code59_Starter_33LB_V18.BIN (also tried SBNova_Stock_V18.bin)
> - Cannot connect datamaster to aldl (xtreme usb aldl) (works fine with
> stock memcal connected)
> - tried different timings, tried latency 1 on com port
> - Cannot connect tunpro rt to aldl
> - vehicle seems to be running in limp mode
> - when I swap back to stock memcal everything works fine.(aldl and
> datamaster)
>
> I am attaching images of the hook-up.
> - ostrich switches toward usb - 28 pin mode
> - using supplied ribbon cable
> - using g1 package - tried without ZIF also.
>
> Vehicle has good voltage and grounds.
Edit - Found a pin on the G1 adapter not soldered properly - just re-soldered and everything worked
