Re: Lower intake gasket PROBLEM FOUND
Boostedpimp said:
Don, What kind of issues have you been having that prompted you to read up on the possible shitty gasket job from the factory?? I know ed hess in the past chased a horrible idle issue and finally chalked it up to the same deal I believe
Well call it what you want. The pictures tell the story. Here’s a brief history.
For prolly over a year the truck has had a slight miss at idle but ran fine otherwise. Pulled good (although this year I never approached the 13.000 that I ran late last year) and it ran just fine at anything off idle. Only other symptom was an occasional slight hesitation coming off idle. End of ’06 comes and it’s smog check time. Passes 2500 RPM test just fine, fails miserably at idle. HC’s 344, allowed 120. So I start throwing parts at it.
New:
3” highflow cat, muffler delete.
EGR valve
2 new 02 sensors (first one was bad)
Rebuilt throttle body (my original shaft was loose)
Rebuilt dist (paid a very well respected local shop to tell me my original one was, in fact, bad. The also tested the o2) Paid again to verify that ign was “perfect” and o2 good.
Even bought a MSD 6al. (Ran a little better, started much better) but,
after all that and many free “manual” tests at my smog guy that same old miss is still there. Made lots of progress on the idle test but still not quite there. (I owe that guy)
Last resort, send my other set if injs to Mike at RPM, they flow perfect. So I’ve got the top of the engine apart the install them and the old gut feeling says you’re this far, and I’ve seen dalwine250’s post so off comes the lower intake and there it is.
BTW I also reset the lifter preload and found nothing amis.
After everything is back together it's gonna feel like a first date at the smog shop, it darn well better pass this time.