STG Ultimate Install

[SY1373]

I have installed the 3 bar map sensor and chip and now can't get the Sy to run. Check engine light comes on (per directions) check gauges light flashing. Truck turns over but will not fire. Can anyone please point me in the right direction?

Thank you.

 

[TYPHOOL7]

check to see what mode the chip is in it may be in sec, or valet mode which is for security, the truck should do that. Turn the key not all of they way on but forward, put the little key in the chips display area thingy and turn it to the 1st 16lb setting, that should work but im a Phool you never know!

 

[syntax]

make sure the chip is seated properly, also, did you piggy back the stock chip? you have to or it wont work, make sure all the vac lines and the sensor are plugged into the 3bar

 

[SY1373]

I forgot to mention the codes display fine and are set @ T115.

 

[SY1373]

With the ultimate I still need to utilize the stock chip? Didn't get that from the directions - guess that could be my problem. I need electronics for dummies instructions. The 3 bar sensor connections have been rechecked.

Thanks - Buck

 

[TYPHOOL7]

thats the only other thing, did you put the stock chip on too, and properly if so? i just read your post above try it, it will work!

<font size=-1>[ This Message was edited by: TYPHOOL7 on 2002-03-18 20:14 ]</font>

 

[E-Rue]

where is roper NC?

if its anywhere near raleigh, or cary, ill be glad to help you out. email me.

e