New box for Sy

killerrudy

New member
Well I finally got done with measuring everything 50 times to get the maximum space which just happens to be right at Kickers minimum for the sub (.79 cu ft) they want .8 . Well let me know what you think

100_0570.jpg

The tab off to the left is a mount for the amp. So it fits around the jack enclosure

100_0571.jpg
 

killerrudy

New member
Re: New box for Sy

Well the tolerances are tight enough that I have to take out the center console to get it in. Going to do that in the morning. Tight fit, but hope it brings out a little sound in the truck
 

Tophatjimmy

Syclone FNG
Re: New box for Sy

looks pretty sweet. I'm anxious to hear your impression of the shallow Kickers.

Right now I'm running a pair of the shallow ED 10" subs and they do ok, but I've been eying the Kickers.....
 

killerrudy

New member
Re: New box for Sy

Got the box in. Had to take the center console out to fit it in! Sucked. Got the amp in the mail yesterday and mounted. Wiring to come soon!

100_0577.jpg
 

4C FED

Absolutum Dominium
Re: New box for Sy

Looks good.
Why did you decide to mount the driver behind the console rather than behind the seat?
 

killerrudy

New member
Re: New box for Sy

Had the thought that a continuious resination in my back would rattle my brain loose after a while! So shooting in between might be less annoying. Not a sound engineer though. So it might of been better the other way.
 

4C FED

Absolutum Dominium
Re: New box for Sy

Not a sound engineer though. So it might of been better the other way.
Me either. I think that bass signals are typically considered non-directional. However, you can increase the effectiveness by placing a sub in the corner rather than in the middle.

I know when I had the sub in my house in a corner of a room the output was much greater than when I had it in the middle of a 20' wall.

Either way, it will certainly add to what you have. :tup:
 

killerrudy

New member
Re: New box for Sy

Me either. I think that bass signals are typically considered non-directional. However, you can increase the effectiveness by placing a sub in the corner rather than in the middle.

I remember that when I had a sub in my old celica if I fired it directly into the cabin it was okay, but when I turned it around and refracted the sound waves off the rear of the car, it got much deeper sounding bass. So hopefully the console isn't too close and ruines the sound/or rattles annoyingly.
 

killerrudy

New member
Re: New box for Sy

No click loss!!!! But I don't sink in quite as far as I used to in the seat! So if I move it up one, the seat doesn't touch at all! So I made it almost perfect. I would of lost a little bit less room if I made a bend in the middle of the face and I barely made the cu ft requirement as it is.
 
Last edited:

killerrudy

New member
Re: New box for Sy

I had a request for measurements and so forth, so if you guys want to build one, here is the ultra complex CAD drawings that I did on my super CAD program this morning. Okay it was just microsquish paint!

boxdiagram.jpg


Forgot to add that when you put it in, you will need to take out your center console to fit. When your done, there is about a fingers width in between the subbox and the console! "LIKE A GLOVE!!!"
 

killerrudy

New member
Re: New box for Sy

Well, I just got the head unit in the mail today and got it all wired up. I will put up a picture tomorrow of the amp all wired in. Sounds way better than I imagined. That little 10" kicker does exactly that!!
 

dgoodhue

BuSTeD 4.3
Re: New box for Sy

Looks good.
Why did you decide to mount the driver behind the console rather than behind the seat?

If the subwoofer cone hits the back of you seat it affects the souind quality. Also when someone sits int eh driver seat, the seat reduce the clearance room even more. I found out pretty quickly that you need a good 3/4" to 1" of clearnace between the sub and the seat.
 

killerrudy

New member
Re: New box for Sy

Okay here is the promised picture of the finished install

100_0583.jpg

Went straight down through the flooring with the ground and battery wire.

100_0581.jpg

This is the DUAL headunit I have been trying out. Not to bad. HD Radio sounds good and streaming media via bluetooth is pretty awesome.
 

Mephisto

These trucks are cursed
Re: New box for Sy

question regarding the head unit... i notice a usb input on the front... can you just plug in a 4gb thumb drive full of tunes and shuffle through the songs via the head unit?

i've noticed quite a few new head units having a bunch of different aux inputs on them now... always wondered if that was an option, before i blow 5 or 600 on a dvd-r deck...

i just hate all the restrictions with ipods and would rather not get one if i don't have to.
 

killerrudy

New member
Re: New box for Sy

666 Sothis 666;677286 can you just plug in a 4gb thumb drive full of tunes and shuffle through the songs via the head unit? .[/QUOTE said:
Yep! Just like that. And it comes with an Ipod cable that uses both plug'ins. Even works with the new 3g Iphone. Charging that is. I know that it is a cheap headunit, but it has lots of features.
 

AutoVation

Member
Re: New box for Sy

VERY nice work on the sub box.:tup:

Dimensions are close to some enclosures I was looking at from Crutchfield:

http://www.crutchfield.com/p_236S100S/Bass-Slammer-S100S.html?tp=127

killerrudy / Crutchfield:
Width: 27" / 22-1/4"
Height: 20-4/5" / 15-3/4"H
Depth 1: 1-1/4" / 4-3/4"D1
Depth 2: 6-1/2" / 6-1/2"
Material thickness: 5/8" / 1/2"
Volume: .79 cu ft / .83 cu ft.

Basically, yours is a couple inches wider and taller to maximize space. What I don't understand is you say your volume is .79 and the 'smaller box' from Crutchfield says a volume of .83. Is that because they are using 1/2" vs the 5/8" thick material you are using?

IMO, the killerrudy box looks like a better solution (and more aesthetically pleasing also). If you want a quick and dirty box for the Sy, a similar box is available from Crutchfield ($99 for 2 boxes so buy 1 and put 1 up for sale in the classifieds or use both...).
 
Top