McCord Power Plate ?s

SY756

New member
I did a search on the McCord dumps and found that Michael H has one. Has anyone else had any experiance with this brand of cutout? Michael, if your out there, how's yours holding up? I know that there was a GP on some that were going to be $159 or so but the McCord is $105 + s/h. They also offer a GP. Here's the link.

http://www.mccordcg.com/mpp/mpp.htm

Now that I had to put a muffler on I want the option to run open dump and switch to quiet if I see any police. I've been just running it open dump but I've had too many close calls.
TIA
 

ed hess

race or get outta the way
I bought the one mike hood had.

works fine for me!

Real nice to not have to crawl under truck at the track, especially at 11pm when its time to go home.....now if i could only get this tranny governor to arrive so i can finally get to the track again....

ed
 

sytyguy

Moderated User
Yeah, Ed bought mine. It worked fabulous for me while I had it. Only had one problem....My dump is right where the bed/cab meet angled out towards the p-side. With it in this location, the motor on the side of the MPP hung down too low for my liking. You can rotate it on the 3 bolt flange, but in any other configuration it either hit the frame or the motor was awfully close to the rest of the exhaust. This is also the reason I sold mine. Figured I could use the money until I redesigned my exhaust, at which point I will repurchase the MPP.

HTHs

Michael
 

ed hess

race or get outta the way
larry
I have the pte dp. the dump is aimed straight down. No clearance issues on my truck.
Only thing i had any issues with was the gasket. If you figure out which collector gasket is the correct one on the bolt holes and the od and id let me know. I matched up one that was as close as i could get at pep boys one sunday morning but i beleive there are gaskets made which will give a better seal than what i have.
just one more thing for me to do yet.
ed
 

SY756

New member
ed hess said:
larry
I have the pte dp. the dump is aimed straight down. No clearance issues on my truck.
Only thing i had any issues with was the gasket. If you figure out which collector gasket is the correct one on the bolt holes and the od and id let me know. I matched up one that was as close as i could get at pep boys one sunday morning but i beleive there are gaskets made which will give a better seal than what i have.
just one more thing for me to do yet.
ed

Cool, I probably won't get to mine anytime soon I dont drive it that much right now anyway, no A/C. We are closing on our new house hopefully this Friday. So then there isn't going to be any "free" time anymore for a while. Just that "honey-do" time. Hang this, move that :-? At least I'll have a garage again.
 

ed hess

race or get outta the way
one more thing.

I had the pass inner liner out so i ran the wires into the truck thru the antenna rubber and then to my underdash console.

ed
 
Top