Re: Compass / outside temp guage for overhead console
Sorry for the quality plugged in and known to work!!!...
Click for bigger...
Wiring instructions
"If you install a new compass, use the following procedure in order to calibrate the compass:
Turn the ignition switch to the RUN position.
Depress and hold both the US/MET and the ON/OFF or the MODE buttons for approximately 10 seconds, or until the display reads CAL or C.
Drive the vehicle in a complete circle 3 consecutive times. The symbol turns off when the compass is calibrated. The compass will then function normally "
The yellow wire of the sensor goes to ground.. you can connect the power and dimmer lines from the stereo harness. The drac is tapped down near the cruise control module..
-Matt