Cab corner paint - Ideas, thoughts?

turbodig

Active member
I have the following issue on the cab corners behind the bed (underneath, where the rocks fling from the tires). This was beginning to show rust in the "snakes". This is 19k mile original paint.

DSC_0076.JPG


I'm kicking around a few ideas-

Prime and paint back to original

Spray POR-15/KBS, then hit with primer/original paint

Black bedliner material (only in areas where it couldn't readily be seen).


I'd really like to do something more than what the factory did, because there's nothing to prevent it from happening again. On the other hand, I don't want to do something that will be a PITA to restore if she ever gets a full OEM restore job.

I have similar issues with the bottom of the bed- it's almost impossible to replicate the finish it had, primer with black overspray with fender undercoat overspray. Going theory here will be a slightly darkened gray of the KBS coatings stuff. Not 100% accurate, but looks close enough, and can be painted over if ever the crazy notion of OEM restore takes hold.

Inside of the bed is gonna be bedlinered, so I will have some of that stuff...

Thoughts/suggestions/things I haven't thought of?
 

turboj91

New member
Re: Cab corner paint - Ideas, thoughts?

Fine textured chip guard and paint over that. Find the right stuff and it looks like orange peel rather than chipguard.
 

nallj92

Active member
Re: Cab corner paint - Ideas, thoughts?

yep, rock guard painted on, you can make it thin or thick as you want, and will hold up good

also you could look at putting the 3m clear adhesive over it like i have on the front of mine, so that it wont rock chip once its sealed with good paint. you could cut the size you desired and lay it on, then when done you could peel it right off.

is the rust from chips and coming from the outside or underneath the paint?
 

Sportmachines

Active member
Re: Cab corner paint - Ideas, thoughts?

If you do a texture, undercoat like paint, use something with micro texture, like wurth. With those miles, I would do as nall said, touch it up with factory paint and put the 3m clean cover over it. It will keep it nice and most oem. And easiest to restore if it ever comes to that. Hth
 

turbodig

Active member
Re: Cab corner paint - Ideas, thoughts?

yep, rock guard painted on, you can make it thin or thick as you want, and will hold up good

also you could look at putting the 3m clear adhesive over it like i have on the front of mine, so that it wont rock chip once its sealed with good paint. you could cut the size you desired and lay it on, then when done you could peel it right off.

is the rust from chips and coming from the outside or underneath the paint?

Yeah, the rust is from the rock chips breaching the surface, then moisture gets behind it. Metal behind it is perfect.

I kinda like the 3m film idea.. wouldn't take much of it under there, and it's relatively flat surface.

Appreciate the ideas, guys.
 
Top