nightdiver
Active member
What if i replace the output shaft with a long corvette shaft ? I also got the rear cover . will this work with the rear prop ? Im building a rear drive race car with GB tranny here
700r4 tail Q?
- Thread starter nightdiver
- Start date
nightdiver
Active member
Re: 700r4 tail Q?
:tup: :cheers:
:tup: :cheers:
George Blake
DONATING MEMBER
Re: 700r4 tail Q?
Make sure you cryo the long shaft. It'll stress relieve it very well. No nitriding. That'll take out the "give/twist" that longer shaft needs. Nitriding will usually done about .010" deep.
Make sure you cryo the long shaft. It'll stress relieve it very well. No nitriding. That'll take out the "give/twist" that longer shaft needs. Nitriding will usually done about .010" deep.
nightdiver
Active member
Re: 700r4 tail Q?
thanks George i will. I wont use any tranny brake, I will just replace the shaft this week
thanks George i will. I wont use any tranny brake, I will just replace the shaft this week
George Blake
DONATING MEMBER
Re: 700r4 tail Q?
I forgot to tell you, make sure when the suspension binds up in the back that it won't shove the driveshaft forward enough that it will "bottom out" in the trans. That's how the shop across town from me went through a ton of bellhousings.
I forgot to tell you, make sure when the suspension binds up in the back that it won't shove the driveshaft forward enough that it will "bottom out" in the trans. That's how the shop across town from me went through a ton of bellhousings.
nightdiver
Active member
Re: 700r4 tail Q?
Yeah , i had that in mind. Is an inch enough ?
Yeah , i had that in mind. Is an inch enough ?
George Blake
DONATING MEMBER
Re: 700r4 tail Q?
It depends on how bad his rear suspension will wind up. 1" should be plenty as long as everything else is set up correctly.
It depends on how bad his rear suspension will wind up. 1" should be plenty as long as everything else is set up correctly.