Search results

Re: Sy# 2905 For Sale - Melbourne, Florida Thanks for the offer, but I'm keeping it with the truck. :D

Re: Sy# 2905 For Sale - Melbourne, Florida Check out the "Wheels and Tires" forum on syty main forum page. Lot's of helpful hints on wheels. That's where I found what I needed when fitting wheels for my Sy. Good luck!! :D

Re: Sy# 2905 For Sale - Melbourne, Florida Thanks! :D

Re: Sy# 2905 For Sale - Melbourne, Florida Hey SYO237, No... it's my Typhoon wanna be. :D

1991 GMC Syclone For Sale - Good Condition, 109,000 Miles, New ZR1 Wheels 17x11 rears, 17x9.5 fronts. New tires. Runs great. Everything works. $10,200 (321) 432-1184

Re: died wont start Hey Bouser, Ever figure out what was wrong with your TY? I've been slacking lately and have been only working on mine on and off. I've replaced my ECM and IAC. My EGR was fine. I'm starting to believe I have some kind of vacuum leak in the intake system that is...

Re: Died and now won't start A couple of months ago when I replaced the IAC, I did reset the computer and the truck still showed the same issues. I didn't have the Datamaster available at that time and the battery has been very low from sitting. I will attempt to reset the computer again...

Re: Died and now won't start Ok, she's starting to collect a lot of dust in the garage. Since my last post, I've replaced the IAC since the symptons seemed to point to that component. I got it through Advance Discount Auto so I hope it's ok. I reset the IAC and she's still having...

Re: Where is the IAC located? Ok, I replaced the IAC. I performed the task to reset the IAC by jumping the 2 ports on the ALDL. Turned the key to on for 30 seconds and I could her the IAC spinning. I turned off the ignition, pulled the jumper from the ALDL, and then pulled the ECMB fuse...

Re: Where is the IAC located? Ok, I pulled the electrical connector off what I believe to be the IAC which is located in the back of the throttle body and pretty much under neath the hose connecting the inlet and the cooling component. I started the truck and it will run, but at a high...

Re: Where is the IAC located? I'm assuming it's got electrical lines running into it, but does it have vacuum lines running into it as well? I tried to attached a digital picture of the throttle body just to make sure I'm looking at the right thing, but I see there's no method unless I link...

Hello SY/TY Members! :D I'm trying to determine if my IAC is the issue of why my truck will not idle after it warms up. I can get it started with the aid of spraying starter fluid down the turbo inlet, and it will idle for about 10-20 seconds (only cold), but once it warms up, it dies once...

Re: Died and now won't start Well I pulled the coil wire from the distributor cap and checked it using a spark jump tester and I've definitely got spark. The next thing I did was pull the rubber elbow off near the turbo, sprayed starting fluid in it, and cranked it, it started. :D It...

Re: Died and now won't start Hey guys, thanks for the suggestions. Sorry for the late reply, just got back in the Country. Question? How would you test the ignition module to determine if it's bad other than replacing it?

Gotta problem. I drive my SY only on the weekends and a couple of weeks ago when I went to start it, it started for about 1 second and then died. Now it just cranks and cranks and cranks and nothing. :( I started the following diagnostics. 1) Checked fuses. All ok. 2) Check fuel...