Search results

  1. E

    CAC Pump - what is everyone using these days?

    My OEM pump finally died. What is latest thinking on a replacement?
  2. E

    DutchTy upgraded lower IC [CAC] [SOLD]

    $350 shipped to the lower 48. Brand new in box. I never even opened it. SOLD Details are here: http://www.syty.net/forums/showthread.php?t=55809
  3. E

    Sold! - NJ - Lightly ported Brodix heads, rockers and pushrods

    SOLD! Brodix Heads (Lil Brodie’s). These are the -8 part number. More info here: http://www.brodix.com/heads/v6.html I bought these heads 2nd hand. They were intended for a Syclone build that was going to use a TE-44 turbo. The heads were mildly ported and polished by a local engine...
  4. E

    NJ - Balance shaft shortblock – spun main bearing - FREE

    $FREE and you pick up. It’s a 1995-ish motor. Has the stamped steel oil pan and stamped steel timing chain cover. It spun a main bearing which in turn starved the rods for oil (although the rod bearings didn’t spin). In any case it’s a good candidate for a rebuild. It has the stock...
  5. E

    SOLD! NJ - TD06H 14cm 20G low mileage

    TD06H 14cm 20G $400 plus shipping and PayPal fees. SOLD! As you can see in the pics at some point some one did some porting on the exhaust side. The center section was replaced with a new one from Richard Chan back in May of ’04. Since then I have put maybe 500 miles on the turbo (long...
  6. E

    Trying to understand stock wastegate function

    I am doing some shakedown testing with the new mods in my sig. I am using a fishtank bleeder valve to control boost on a stock turbo. Boost control is absolutely horrible with this setup. On launch it will peak to 21-22 PSI and then at higher RPMs the boost falls off to about 12 PSI (probably...
  7. E

    Tranny won't command a 1-2 shift

    This is a fresh rebuild after a hard parts failure. The tranny won't shift out of first. It stays in first until I let up on the gas and then it overruns. We took of the pan and the 1-2 accumulator was full (as should be) and a test indicated that it is applying the bands correctly. We...
  8. E

    What type of rear differentials do our trucks have?

    Open rear or limited slip? I tried searching this forum but was not able to determine a clear answer. If it's supposed to be a limited slip then mine is completely shot, because while holding one wheel, I can easily spin the other wheel by hand. It acts as though it's an open rear. Thanks.
  9. E

    Combustion chamber size of various heads?

    I searched the forum but didn't come up with the answers. I need to know the cc's of the combustion chambers for: 1) Stock Sy/Ty heads 2) Vortec heads and for completeness might as well throw these in: 3) L35's Feel free to add others to the list if you know them... Thanks, Eric
  10. E

    Baffled fuel tank on newer S10's???

    Does anyone know if the later fuel tanks in S10 tanks are baffled and are a drop-in replacement for a Syclone? It's a real pain in the rump to have to keep at least 3/8 tank of gas in the truck and gets expensive when you are running race gas.
Top