Recent content by xblazinlv

Do you know any manuals or guides anyone has wrote about taking apart the dash and steering column? Or did you just go by ear? Mike

Was it a pain in the ass to get to? How long did it take? Mike

My steering column has a lot of play in it, you can wiggle it around all over the place. It doesn't affect steering, but it is an anoyance and can be dangerous if someone else drives the truck. I don't know exactly what is causing it however... could it be the tilt wheel steering is broken? Mike

Race him and find out Mike

Good kill Ben.... you on aim?

Sign onto aim

Nice numbers Ben... Maybe before nats next year I'll drive the syclone up to CO and visit and we can take it to the dyno since there isn't an all wheel drive dyno out here :) Mike

Sup Ben.. I sent out the money order for the mirrors this week... the guy didn't accept paypal :evil: I should have them next week. I also got my new fog lights in today because the ones on the truck are rusted and really dingy compared to the other lights. I will take pics of it with the...

So what about the mirrors off of a Bravada or Blazer from the same year? Do they look nice like the typhoon mirrors or are they ugly like the syclone ones? I have been looking and it looks impossible to find typhoon mirrors. I take it that GM doesn't make them anymore either right? Mike

So does anyone know of a water neck that has one built in that I can buy?? Mike

Does anyone know if that hole below the water neck would work for the sending unit? I think it is where the EGR valve used to go, there is just a hole with a plug in it. Could I get a fitting to adapt for the sender and put it there? Mike

Because it reads that the temperature is 120 degrees.... when it has a 160 thermostat and the last datamaster test showed temps of 160-165 :) I am sure the sending unit is bad or when they put the white face guages in they messed up when they put the needle back on. Mike

I would much rather just get a new water neck that has the probe built into it... do you know anyone that makes one? And on what side is that 3/8 pipe plug you are talking about? Mike

Where can I get the thermostat neck with the built in probe? I would much rather go that way than try and drill the head for a reading. Mike

Where should I post this? How to mod/Repair?