Recent content by 1SYCLONE1

Re: Log vs. Header Im just going to build a log style and Im going to build them while the motor is still in the truck so fitment will be correct unlike the kb's.

Re: Log vs. Header Guys I cant run stock manifolds because I have brodix heads but what Im thinking about doing is just making my own set of log style headers out of some 1 1/2" to 1 3/4"stainless plumbing supplies . I plan on running anywhere between 25-30lbs of boost. Im looking more into the...

Guys, I was just wondering what you all think. Im about to get rid of my kb headers for a set of homemade Iron log style manifolds. Im just sick of the kb's breaking and for the fact that its a pain getting to the plugs especially on the passenger side where you have to take off the entire...

Re: Which cam ? What is this and do they have a site? Thanks.

Re: Which cam ? Thanks guys. The thing that Im trying to avoid is that my truck right now has way to much cam and I dont think that I want or need that with a turbo vehicle. It literally lopes and shakes like a full out drag car at idle. My truck only pulls about 9-10"'s of vacuum right now. I...

Guys, I was wondering what is the best cam to run in our trucks. My truck has brodix,forged rods, upgrading to a precision 76mm, forged pistons. 4-bolt etc......I do plan on using the trucks as a driver and also a lot of 1/4 mile passes. Thanks for any help.

Re: Help! Drivers side header getting red hot under boost!!!!! Truck runs perfect witha perfect a/f. No stumbling or anything. The drivers side header just glows when ever I run it in boost and the passenger side doesnt. Thanks

Hi guys, I have a set of KB headers on my built syclone. I always open the hood to let out the extra heat no matter if I beat on it or not. The problem that Im having is that the driver side header gets red hot( or I should say orange hot) when ever Im under boost but the passenger side seems to...

Re: What would cause my syclone to have no boost sometimes? well when I bring the truck to a stop or close to, the truck acts normal again even though I didnt let it cool down and thats whats confusing me. Do you still think that its a waste gate problem?

Re: What causes to much pressure build up in gas tank? Well can I run the truck without a gas cap or will that also cause problems? Thanks again to everyone that has chimed in:tup:.

Re: What causes to much pressure build up in gas tank? how can I check to see if I have a vented cap or not? Where can I pick a vented cap up at? Will it hurt anything if I run the truck without a gas cap? Thanks.

Re: What causes to much pressure build up in gas tank? will having to much pressure in the tank cause any problems with how the truck performs ?

Just wondering if anyone else has had this problem before. When Im out running the truck hard it will not build boost after a few hard pulls until I almost come to a complete stop then it will build boost again as if nothing is wrong. Its happening when Im out doing hard roll ons and the truck...

Hi, my syclone seems to have a lot of pressure build up in the gas tank every time I go to remove the gas cap. Will this cause any issues or should I not worry about it? It always has a lot of pressure no matter if the tank is near empty or full. Thanks.

Re: Problem with waller built trans. Wont go into over drive at highwat speeds!!!!!!! truck shifts fine without any issues but when accelerating on the highway to get up to speed it never shifts back into O.D. Im lost on this one. Im guessing anything above 55mph is when it does it.