Re: Performance Or Stock Pulleys....
Re: Performance Or Stock Pulleys....
i guess it's a no go @ this point. sorry guys. it was at least worth the effort to try.
well i sat down today and got a quote on all of the material and tried to figure out exactly how much it would cost me to do 10 pieces. By the time i design, program the machine and set the machine up then run the parts my cost on a set of the pulleys is over $500.
some of the things that increased the cost of these pulleys VS the GN pulleys are
#1 there is actually 6 pulleys (an extra idler) instead of the 5 the GN has
#2 the crank, water pump and power steering pulley are significantly larger than the GN pulleys making the material cost go up about 30%
#3 the only pulley i can use off of the GN is one of the idlers.
#4 I usually make the GN pulleys in sets of 40-100pcs. when you have to divide the cost of setting up, programming and design of the parts by 10 instead of the 40-100pcs it makes the parts way more expensive.
after reviewing it, it is not economically feasible to make these pulleys especially since march already makes a kit. it would be foolish for me.
where would you like me to send these pulleys back?
I apologize for not being able to do these for you economically.
RJC Racing
Race Jace
Jason Cramer
435-882-2839
www.RJCRacing.com
Jason@RJCRacing.com
87 Buick Grand National, Stock Block 9.89 @ 136 @ West Coast Nats in Las Vegas 2400 ft. ele.
2002, 2003 & 2004 GSNats TSM Class Winner
----- Original Message -----
From: CHRIS K
To:
Jason@RJCRacing.com
Sent: Thursday, September 28, 2006 3:34 PM
Subject: link to the syclone pulley interest.
http://69.9.37.28/~sytynet/forums/showthread.php?t=41687&page=2
call me when you have a chance to figure out if these are doable. chris keith 1-800-382-0321 mon-sat 8:30 am - 7:00 pm est or my cell 1-803-924-7051 anytime.
thanks for trying to make this work for us.
chris keith
